Video settings

Please Log in to update your video settings

Video will begin in 5 seconds.

Recommended

Replay video

Video settings

Please Log in to update your video settings

Christmas wrapping never looked so good

Simple ways to embellish gifts with Etsy crafter Sally Cooper.

PT4M15S http://www.canberratimes.com.au/action/externalEmbeddedPlayer?id=d-1onem 620 349

Plenty of department stores offer gift-wrapping services at this time of year, thank heavens.

But what if you've got a big pile of unwrapped gifts at home that need to be 'pretty-fied'?

Wanda Wen, author of The Art of Gift Wrapping: 50 Innovative Ideas Using Organic, Unique, and Uncommon Materials has revealed her tips to make the task easier.

Woman wrapping a gift, present.

It's all in the presentation ... wrapping makes gifts extra special. Photo: Jennifer Soo

You'll save paper and ribbon with her directions, and her tips are simple, beautiful, even kind of eco.

The cornerstone of her technique: accurately sized paper, eliminating the gaping and clumping that torment amateur wrappers. The flourish is a ribbon that looks clean and classic, yet goes on without an inch of waste and comes off with a single pull.

You wrap the box with ribbon without cutting it until you're done, ensuring "that you're not cutting a piece of ribbon that's too long or too short," Wen says, "because that's another pet peeve of people, especially if you're using expensive ribbon."

TIPS

1. Put box down on the gift wrap. Cut a rectangle of paper large enough to comfortably wrap the present.

2. Trim the width of the paper: Place the rectangle of paper on the table; put the gift on top. Loosely wrap the paper around the box's width and depth and add 5 centimetres of overlap; trim.

3. Trim the length of the paper: Now place the box on the bottom edge of the rectangle of paper. Stand the box on its end and then push it down and away from you to measure out the length and depth. Again, factor in another 5 centimetres of overlap; trim.

4. Put box, bottom up, in the middle of the paper.

5. Wrap the width: Bring one side of the paper up and, using double-stick tape, affix it to the box. Take the other edge of the paper, fold it in about 1 centimetre (to hide the raw edge), and affix it with the tape to the top of the box. The seam should be in the middle, with no raw edges and no visible tape.

6. Finish ends: Press the paper in toward the box on both the left and the right, forming sharp diagonal creases on the top flap. Tape the top flap to the box. Now form the same sharp creases on the bottom end, but before taping this end to the box, fold in the raw edge about 1 centimetre to create a perfect edge. Tape to box.

7. Gently using your fingertips, create sharp creases along the edges of the box.

8. Now the bow: Don't cut ribbon off the spool. Take the loose end and pull out a length sufficient for one of the bow loops and a tail - about 25 centimetres total. Take that 25-centimetre length and anchor it at the centre of the box, with the loose end dangling off the left side.

9. Holding the spool with your right hand on the right side of the box, and the 25-centimetre tail secured with your left hand, wrap the ribbon around the width of the box one time, come back to the centre, and hold the ribbon with your left hand; now turn the spool end down toward the bottom of the box and wrap the length of the box.

10. Bring the spool end of the ribbon back to the middle of the box, and hold the ribbon with your left hand. Use your right hand to cut another 25-centimetre tail.

11. Bring the new tail down to the bottom left corner of the box and thread it back under the intersection of ribbons at the centre. Tie a bow.

MCT